DB150

DB150 Kommando Station og Booster:

DB150 er en del af startsæt Super Empire og Xtra Builder 5 Amp.

• Fuld LocoNet Kompatibel. DB150 giver dig de ultimative udvidelsesmuligheder!

• Op til 22 kontrolhåndtag på samme tid i kommando stations tilstanden.
• Bruges i forbindelse med LocoNet kontrolhåndtag: DT400 serien, DT300 serien, DT100 serien, UT2, UT4 og andre kompatible LocoNet kontrolhåndtag.

• Built in broadcast write only programmer. Genesis uses Paged Programming method exclusively.

• Built in 5 Amp Digital Command Control Booster Rated at 80VA.

• De fleste Kommando station indstillinger er valgbare af bruger.

Accepterer  50/60Hz AC eller DC input fra en eksisterende strømforsyning (IKKE EN GAMMELDAGS TOG TRANSFORMATOR). Minimum input volt: 12V AC eller DC, Maximum input volt: 22V AC or 28V DC. Den tilsluttede strømforsyning skal være indenfor disse rammer og være overload beskyttet ved et maximum på 4.5 Amp DC.

Auto resetting ved for høj temperatur & kortslutning.

• Digitrax Boosters er sikre at bruge med alle skala idet der er valgbar spænding for N til G skala. N=12V, H0=15V og G=20V.

• Track Status indicator shows voltage and signal type (DCC or "Zero Stretch" Analog Signal for conventional operation.)

• Stabilized Track Drive Output. Over Voltage Protected.

• LocoNet Expansion Network for easy reliable system hook up and future system expansion. All connections are made with 6 conductor telco jacks & wire. The LocoNet wiring scheme gives you a very reliable system for sending your commands to the track and controlling your trains. For future expansion, LocoNet offers you full access to advanced features such as track level feedback for train detection, signaling & automated operation without the need to run a separate bus. LocoNet is more than just wiring, it is a fully integrated train control system.

• Sync output configures DB150 Operating Mode & connects the DB150 to expansion boosters

• High impedance balanced or unbalanced signal input receivers on the LocoNet Interface allow boosting of several different types of command control signals.

• Auto shutdown if command control drive signal is lost so that the layout will not convert to DC operation if a cable or connection is broken. The trains won't just "take-off" if they are not getting the DCC signal.

• Complies with FCC Part 15, Class B RFI Requirements.

• DCC Compatible.

• DB150 kræver særskilt strømforsyning. Kontakt ABC Modeljernbane for at høre nærmere.

For mere information, besøg dette produkts hjemmeside.